Mostrar el registro sencillo del ítem

dc.contributor.author MIRANDA HERNANDEZ, JOSE GUADALUPE
dc.contributor.author SUASTE GOMEZ, ERNESTO
dc.contributor.author GONZALEZ MORAN, CARLOS OMAR
dc.contributor.author HERRERA HERNANDEZ, HECTOR
dc.contributor.author ROCHA RANGEL, ENRIQUE
dc.creator MIRANDA HERNANDEZ, JOSE GUADALUPE; 47542
dc.creator SUASTE GOMEZ, ERNESTO; 2402
dc.creator GONZALEZ MORAN, CARLOS OMAR; 103970
dc.creator HERRERA HERNANDEZ, HECTOR; 87908
dc.creator ROCHA RANGEL, ENRIQUE; 21235
dc.date.accessioned 2017-03-06T18:04:40Z
dc.date.available 2017-03-06T18:04:40Z
dc.date.issued 2014-08-01
dc.identifier.issn 2327-2503
dc.identifier.uri http://hdl.handle.net/20.500.11799/65161
dc.description.abstract This research describes the synthesis of an outstanding ceramic-composite piezoelectric CCP (lead-lanthanum-zirconate-titanate, PLZT) by means of powders technique procedures. Full dense CCP compacts were obtained with a platinum wire implanted in the center of the piezoelectric, which were used to investigate the microstructural and opto-thermal properties. The microstructural details of this ceramic were investigated by optical microscopy; whereas the opto-thermal characterization was performed by measuring the electrical signal in a bidimensional setup under four different temperatures: 20°C, 35°C, 50°C and 75°C. A 160mW/cm2 LASER beam was used in order to produce the optical energy which is detected by the CCP. A total of one hundred of measurements were registered. Measurements showed that, in the explored thermal range, the CCP signal magnitude increased from 87.2 to 147.2 pA. About the microstructural analysis, the microstructure obtained show different phases as characteristic of the processing method, including porosity. The peculiar optical and thermal properties observed in the piezoelectric ceramic are promising for possible applications in temperature-controlled optical devices that require electrical outputs. es
dc.language.iso eng es
dc.publisher Science Publishing Group es
dc.relation.ispartofseries Vol.;3
dc.relation.ispartofseries No.;3
dc.rights openAccess es
dc.rights.uri http://creativecommons.org/licenses/by-nc-nd/4.0
dc.subject piezoelectric es
dc.subject ceramic es
dc.subject plzt es
dc.subject opto-thermal es
dc.subject pt wire implanted es
dc.subject.classification BIOLOGÍA Y QUÍMICA
dc.title Synthesis and Electrical Characterization of PLZT Piezoelectric-Ceramic es
dc.type Artículo es
dc.provenance Científica es
dc.road Dorada es
dc.organismo Centro Universitario UAEM Valle de México es
dc.ambito Internacional es
dc.cve.CenCos 30501 es
dc.cve.progEstudios 43 es
dc.audience students
dc.audience researchers
dc.type.conacyt article
dc.identificator 2


Ficheros en el ítem

Este ítem aparece en la(s) siguiente(s) colección(ones)

Visualización del Documento

  • Título
  • Synthesis and Electrical Characterization of PLZT Piezoelectric-Ceramic
  • Autor
  • MIRANDA HERNANDEZ, JOSE GUADALUPE
  • SUASTE GOMEZ, ERNESTO
  • GONZALEZ MORAN, CARLOS OMAR
  • HERRERA HERNANDEZ, HECTOR
  • ROCHA RANGEL, ENRIQUE
  • Fecha de publicación
  • 2014-08-01
  • Editor
  • Science Publishing Group
  • Tipo de documento
  • Artículo
  • Palabras clave
  • piezoelectric
  • ceramic
  • plzt
  • opto-thermal
  • pt wire implanted
  • Los documentos depositados en el Repositorio Institucional de la Universidad Autónoma del Estado de México se encuentran a disposición en Acceso Abierto bajo la licencia Creative Commons: Atribución-NoComercial-SinDerivar 4.0 Internacional (CC BY-NC-ND 4.0)

Mostrar el registro sencillo del ítem

openAccess Excepto si se señala otra cosa, la licencia del ítem se describe cómo openAccess

Buscar en RI


Buscar en RI

Usuario

Estadísticas